Impact of Alpha on PLA Converging
Two of the questions (7 & 9) ask how many iterations it takes for the PLA to converge. I would expect this to be a function of both the size of N that was mandated as well as the alpha (learning rate) that is selected. Is this not correct?

Re: Impact of Alpha on PLA Converging
Thanks! I didn't realize that the learning rate wasn't present in the model you had discussed during the first lecture. I had previously run all my data at .5 so it will be interesting to see what the difference is when I set it to 1.

Re: Impact of Alpha on PLA Converging
If you take a deeper look at the steps of the PLA algorithm, you'll find that setting the learning rate to any positive value gives you equivalent results (subject to the same random sequence and equivalent starting weights, of course). For instance, if you start with the zero vector, the final weights that you get for learning rate 1 are simply twice the final weights that you get for learning rate 0.5. ;)

Re: Impact of Alpha on PLA Converging
Quote:
I would expect that if your learning rate is too large it would be possible to "overshoot" the convergence values and therefore require some back and forth before they settle. Depending upon the extent of that oscillation it may or may not require more iterations than a smaller value. I guess you could also say a similar thing about too small a learning value. It could slowly inch up to one possible set of convergence weight values and get stuck in a "local minima" of sorts without truly finding the "global minima". 
Re: Impact of Alpha on PLA Converging
Quote:

Re: Impact of Alpha on PLA Converging
Quote:
After thinking about why this is the case I can almost understand it :) Thanks for following up on my original question! 
Re: Impact of Alpha on PLA Converging
What is the range that we should expect the weighting factors to be around? Should it be less than 1, less than 10, or greater?
Any help appreciated  thanks. 
Re: Impact of Alpha on PLA Converging
Quote:

Re: Impact of Alpha on PLA Converging
In my simulation, I plotted the random data points and the "true" f(x) line, and it helped me intuitively see that with many points (e.g. N=100), there is much less "wiggle room" for two lines to fit between the same set of "boundary" points (i.e. the set of points that are "closest" to the f(x) line.) With less points (say, N=10), there could be a huge variation in the slope and intercept of two lines that both "fit" the data.
I would think that you could get a better starting point than w = 0 by examining the data at the "boundary" points, where the result y changes from 1 to +1 and somehow use that information? 
All times are GMT 7. The time now is 07:02 AM. 
Powered by vBulletin® Version 3.8.3
Copyright ©2000  2020, Jelsoft Enterprises Ltd.
The contents of this forum are to be used ONLY by readers of the Learning From Data book by Yaser S. AbuMostafa, Malik MagdonIsmail, and HsuanTien Lin, and participants in the Learning From Data MOOC by Yaser S. AbuMostafa. No part of these contents is to be communicated or made accessible to ANY other person or entity.