LFD Book Forum (http://book.caltech.edu/bookforum/index.php)
-   Chapter 2 - Training versus Testing (http://book.caltech.edu/bookforum/forumdisplay.php?f=109)
-   -   bias-variance plot on p67 (http://book.caltech.edu/bookforum/showthread.php?t=4767)

 Steve_Y 05-24-2017 11:33 PM

bias-variance plot on p67

Hi Prof. Abu-Mostafa,

As you suggested, I post below the question that I emailed you earlier, in case other people also have similar questions. However, I couldn't seem to insert/upload images properly here (it showed only a link), so I'll just do a text-only question.

Specifically, Im a little confused about the bias-variance plot at the bottom of page 67. In the plot, the bias appears to be a flat line, i.e. constant, independent of the sample (training set) size, N. I wondered if this is (approx.) true in general, so I did some experiments (simulations). What I found was that while this was indeed approximately true for the linear regression; it didnt appear so true when I used the 1-nearest-neighbor (1-NN) algorithm. (Similar to Example 2.8, I tried to learn a sinusoid.)

More specifically, for the linear regression, the averaged learned hypothesis, i.e. "g bar", stays almost unchanged when the size of the training set (N) increases from 4 to 10 in my simulation. Even for N=2, "g bar" doesnt deviate too much.

However, for the 1-Nearest-Neighbor (1-NN) algorithm, "g bar" changes considerably as N grows from 2 to 4, and to 10. This seems reasonable to me though, because as N increases, the distance between a test point (x) and its nearest neighbor decreases, with high probability. So its natural to expect "g bar" to converge to the sinusoid, and the bias to decrease as N increases.

Here's the simulated average (squared) bias when N was 2, 4, and 8:
OLS: 0.205, 0.199, 0.198
1NN: 0.184, 0.052, 0.013
where OLS stands for ordinary least squares linear regression.

Do these results and interpretations look correct to you? Or am I mistaken somewhere? Id greatly appreciate it, if youd clarify this a little bit more for me. Thanks a lot!

BTW, in my simulation, the training set of size N is sampled independently and uniformly on the [0,1] interval. I then averaged the learned hypotheses from 5000 training sets to obtain each "g bar".

Best regards,
Steve

 magdon 05-25-2017 06:07 AM

Re: bias-variance plot on p67

Your observations are correct. The bias is only approximately constant. Only for a linear model and linear target is the bias constant. In general, the bias converges very quickly to a constant. This is because there is some "best" and for any N, the final output g will be "scattered" around this , sometimes predicting above on a particular x and sometimes below, on average giving the prediction of . This results in being approximately for any N.

The above discussion does not hold for nonparametric models like Nearest Neighbor which do not fit the paradigm of a fixed hypothesis set. When N increases, the "hypothesis set" gets more "complex" and so the bias decreases with N (as your very nice experiment verifies). I congratulate you on delving deeper into the bias-variance decomposition and discovering this subtle phenomenon. If you would like to know more about this, you may refer to the section on Parametric versus Nonparametric models in e-Chapter 6 and also the discussion of the self-regularizing property of Nearest Neighbor just before section 6.2.2 where we show some pictures to illustrate how the Nearest Neighbor hypothesis gets "more complicated" as you increase N.

 Steve_Y 05-25-2017 11:20 PM

Re: bias-variance plot on p67

Quote:
 Originally Posted by magdon (Post 12666) This is because there is some "best" and for any N, the final output g will be "scattered" around this , sometimes predicting above on a particular x and sometimes below, on average giving the prediction of . This results in being approximately for any N.
Thank you very much, Prof. Magdon-Ismail, for the clarification, pointers, and encouragement!

Just one more question: in the quote above, when you said "there's some best ", did you mean the best in current hypothesis set for the current error measure, independent of N? For example, if consists of linear models and the error measure is mean squared error, then would be the LMMSE estimate? Thanks a lot!

 magdon 05-30-2017 06:46 AM

Re: bias-variance plot on p67

Quote:
 Originally Posted by Steve_Y (Post 12668) Thank you very much, Prof. Magdon-Ismail, for the clarification, pointers, and encouragement! Just one more question: in the quote above, when you said "there's some best ", did you mean the best in current hypothesis set for the current error measure, independent of N? For example, if consists of linear models and the error measure is mean squared error, then would be the LMMSE estimate? Thanks a lot!
Yes, best in the current hypothesis set (and should be fixed as you increase N). Note, bias and var are only defined for the MSE error measure, and yes would be the least MSE estimate that is available within (so is independent of N)?

 All times are GMT -7. The time now is 07:26 AM.